The Denim Back Brace is designed to give good support for the back with additional lumbar support.
The narrow front design is best for bending or digging. The wide front design is best for leaning or stretching.
Inside the Back Brace is foam. This is permanently sewn in position to prevent the Back Brace from moving and causing discomfort.
The Back Brace should only be worn when doing work that is likely to cause strain and pain. Do not wear it permanently, as this may make normal muscles lazy. This is a general guide and we recommend advice from your Therapist.
To Fit
Ensure the elastic Brace straps are loose and put the belt on with the middle of the belt centred over the spine at the affected area. Hold the two central pieces of elastic and pull them forward simultaneously and secure them with the Hook & Loop Tape to the main belt.
Next, hold the two double elastic straps and once again, pull them forward simultaneously, to be secured on top of the central elastic. In some cases the elastic straps may be secured above or below the middle of the back brace, depending on individual problems, and consultation with your Therapist is recommended. Fasten all Hook & Loop Tape pieces before washing.
Only use the Denim Back Brace when doing your heaviest activities. Do not wear it all day.
Also available in our back support range:
Back Strap – Lumbar |
|
Back Strap – Pelvic | |
Comfort Back Brace | |
Sacroiliac Belt |
View our entire range of Physiotherapy Equipment here.
Previous SKU: 380 381 382 383 384 385 386 387 388